Gasket makers, thread lockers, glass kits

Categories

07/10/2026 26

JCB JS200–JS260 Monitor Messages: What They Mean and What to Check

On JCB JS200, JS210, JS220, JS240 and JS260 tracked excavators with the AMS control system, the monitor in the cab shows the working mode, the time, gauges for oil temperature, coolant temperature and fuel level, and warnings in the message line. Each message first of all points to a real problem: low fuel or coolant, a blocked filter, overheating. But if a message stays on after the cause has been put right, the sensor, wiring or controller is at fault. Below is what each message means and what to check, based on Section C of JCB service manual 9803/6400.

07/10/2026 34

JCB JS200–JS260 Track Tension: How to Check the Sag and Adjust the Tracks

Track tension on the JCB JS200, JS210, JS220, JS240 and JS260 tracked excavators should be checked every shift. With the track raised off the ground, the gap between the underside of the track frame and the top of the track shoe at the fourth bottom roller from the front should be 275–295 mm on hard ground and 320–340 mm on soft sand and sticky clay. Tension is adjusted with grease through the valve on the track adjuster cylinder. The procedure below follows Section 3 of JCB service manual 9803/6400.

07/10/2026 22

JCB 3CX and 4CX Dipper Ram Creep: Causes, Ram Creep Tests and Repair

If the dipper of a JCB 3CX or 4CX backhoe loader drops on its own under load, there are three possible causes: a leaking piston seal in the ram, spool leakage in the excavator valve section, or a leaking auxiliary relief valve (ARV) in that section. The JCB service manual gives a test procedure that identifies the culprit before the ram is removed and stripped. Below are the test sequence, the permitted creep and the repair rules from Section E of service manual 9803/3290.

07/10/2026 26

JCB 3CX and 4CX Hydraulic Oil: HP32 or HP46, System Capacity and Changing the Oil

For the hydraulic system of JCB 3CX and 4CX backhoe loaders, the JCB service manual recommends ISO VG32 oil — JCB Hydraulic Fluid HP32 — at air temperatures below +38 °C. The more viscous ISO VG46, JCB High Performance Hydraulic Oil, is for air temperatures above +38 °C only. Machines with Advanced EasyControl joysticks need a separate all-season HV class oil, JCB Multigrade Anti Shear. The hydraulic system holds approximately 130 litres. The oil is changed every 2000 hours and the filter at every 500-hour service.

07/10/2026 33

JCB 3CX and 4CX Antifreeze: Which Coolant to Use, How Much and How to Change It

On JCB 3CX and 4CX backhoe loaders with the JCB Dieselmax engine, the coolant is renewed every two years, at the 2000-hour service. The cooling system holds 18.5 litres. The JCB service manual calls for an ethylene glycol antifreeze to ASTM D6210 with corrosion inhibitors and rules out organic acid technology (OAT) products. The standard mix is 50%, which gives protection down to −40 °C. Below we cover choosing, checking and changing the antifreeze as described in Section 3 of JCB service manual 9803/3290.

Sealants and adhesives: RTV silicone gasket makers (black, grey, red), anaerobic thread lockers (removable blue and permanent red), a self-vulcanising adhesive, rubber glue, tyre repair kits and glass bonding kits.

Silicone gasket maker is used instead of or together with a gasket; check its temperature rating. Blue thread locker is for removable joints, red for permanent ones. Cab glass is in the cab glass category, seals and oil seals in seals and oil seals. One level up is the oils and greases category.

All items in this category are aftermarket. Prices are given on request: press «Request price» and state the product name, pack size and quantity.

Default Name Model

5484

5484 professional tyre repair kit, aftermarket

In stock

0,00 ₺

9-AB-R

ABRO 999 grey sealant, aftermarket

In stock

0,00 ₺

А12В

ABRO Masters black sealant, aftermarket

In stock

0,00 ₺

11-AB-CH-RE-S

ABRO Masters red sealant, aftermarket

In stock

0,00 ₺

14537

ABRO TL-010-BL blue threadlocker, 10 ml, aftermarket

In stock

0,00 ₺

40444

ABRO TL-010-RD red threadlocker, 10 ml, aftermarket

In stock

0,00 ₺

TL-371

ABRO TL-371 red threadlocker, 6 ml, aftermarket

In stock

0,00 ₺

9930

Black RTV silicone sealant, 100 g, aftermarket

In stock

0,00 ₺

9934

Grey RTV silicone sealant, 100 g, aftermarket

In stock

0,00 ₺

KPC440GB

KPC self-vulcanising cement, 440 ml, aftermarket

In stock

0,00 ₺

200СС

Maruni 200CC tyre repair cement, 200 ml, aftermarket

In stock

0,00 ₺

23942

Maruni 23942 tyre repair cord set, aftermarket

In stock

0,00 ₺

NF 1007

NF 1007 glass bonding kit, aftermarket

In stock

0,00 ₺

9931

Red RTV silicone sealant, 100 g, aftermarket

In stock

0,00 ₺

23634N

RUSEFF 23634N blue threadlocker, 10 ml, aftermarket

In stock

0,00 ₺

TL-342

ABRO TL-342 blue threadlocker, 6 ml, aftermarket

In stock

0,00 ₺

AS301

AXIOM AS301 blue threadlocker, 10 ml, aftermarket

In stock

0,00 ₺

AS302

AXIOM AS302 red threadlocker, 10 ml, aftermarket

In stock

0,00 ₺

9052

BOOMER 9052 glass bonding kit, aftermarket

In stock

0,00 ₺

7641

LiquiMoly 7641 grey sealant, 80 ml, aftermarket

In stock

0,00 ₺

6185/2859

LiquiMoly black sealant, 200 ml, aftermarket

In stock

0,00 ₺

NF 1125

NF 1125 glass bonding kit, aftermarket

In stock

0,00 ₺

Showing 1 to 22 of 22 (1 Pages)