Oils and greases: engine, transmission, hydraulic

Categories

07/10/2026 26

JCB JS200–JS260 Monitor Messages: What They Mean and What to Check

On JCB JS200, JS210, JS220, JS240 and JS260 tracked excavators with the AMS control system, the monitor in the cab shows the working mode, the time, gauges for oil temperature, coolant temperature and fuel level, and warnings in the message line. Each message first of all points to a real problem: low fuel or coolant, a blocked filter, overheating. But if a message stays on after the cause has been put right, the sensor, wiring or controller is at fault. Below is what each message means and what to check, based on Section C of JCB service manual 9803/6400.

07/10/2026 34

JCB JS200–JS260 Track Tension: How to Check the Sag and Adjust the Tracks

Track tension on the JCB JS200, JS210, JS220, JS240 and JS260 tracked excavators should be checked every shift. With the track raised off the ground, the gap between the underside of the track frame and the top of the track shoe at the fourth bottom roller from the front should be 275–295 mm on hard ground and 320–340 mm on soft sand and sticky clay. Tension is adjusted with grease through the valve on the track adjuster cylinder. The procedure below follows Section 3 of JCB service manual 9803/6400.

07/10/2026 22

JCB 3CX and 4CX Dipper Ram Creep: Causes, Ram Creep Tests and Repair

If the dipper of a JCB 3CX or 4CX backhoe loader drops on its own under load, there are three possible causes: a leaking piston seal in the ram, spool leakage in the excavator valve section, or a leaking auxiliary relief valve (ARV) in that section. The JCB service manual gives a test procedure that identifies the culprit before the ram is removed and stripped. Below are the test sequence, the permitted creep and the repair rules from Section E of service manual 9803/3290.

07/10/2026 26

JCB 3CX and 4CX Hydraulic Oil: HP32 or HP46, System Capacity and Changing the Oil

For the hydraulic system of JCB 3CX and 4CX backhoe loaders, the JCB service manual recommends ISO VG32 oil — JCB Hydraulic Fluid HP32 — at air temperatures below +38 °C. The more viscous ISO VG46, JCB High Performance Hydraulic Oil, is for air temperatures above +38 °C only. Machines with Advanced EasyControl joysticks need a separate all-season HV class oil, JCB Multigrade Anti Shear. The hydraulic system holds approximately 130 litres. The oil is changed every 2000 hours and the filter at every 500-hour service.

07/10/2026 33

JCB 3CX and 4CX Antifreeze: Which Coolant to Use, How Much and How to Change It

On JCB 3CX and 4CX backhoe loaders with the JCB Dieselmax engine, the coolant is renewed every two years, at the 2000-hour service. The cooling system holds 18.5 litres. The JCB service manual calls for an ethylene glycol antifreeze to ASTM D6210 with corrosion inhibitors and rules out organic acid technology (OAT) products. The standard mix is 50%, which gives protection down to −40 °C. Below we cover choosing, checking and changing the antifreeze as described in Section 3 of JCB service manual 9803/3290.

Default Name Model

4004/0502, 4003/4005

JCB Waxoyl Black 4004/0502 anti-corrosion wax, 5 l, genuine

In stock

0,00 ₺

J1927

JSI Hydro ISO 32 hydraulic oil, 20 l, aftermarket

In stock

0,00 ₺

J2111Li18

JSI J2111Li EP2 blue multipurpose grease, 18 kg, aftermarket

In stock

0,00 ₺

J3006

JSI TO-4 SAE 30 transmission oil, 20 l, aftermarket, option 2

In stock

0,00 ₺

3802

LiquiMoly 3802 threadlocker, 0.05 kg, aftermarket

In stock

0,00 ₺

7641

LiquiMoly 7641 grey sealant, 80 ml, aftermarket

In stock

0,00 ₺

6185/2859

LiquiMoly black sealant, 200 ml, aftermarket

In stock

0,00 ₺

3900

LiquiMoly Fliess-Fit K diesel anti-gel, 0.25 l, aftermarket

In stock

0,00 ₺

97720

Loctite 97720 black sealant, 200 ml, aftermarket

In stock

0,00 ₺

LP Special HP

LONMADI LP Special HP grease, 400 g, aftermarket

In stock

0,00 ₺

ce9b5398-d49e-11ee-908a-00155d46f6cb

LUBRISET blue multipurpose grease, 420 g, aftermarket

In stock

0,00 ₺

48011

Meguin HLP R 32 hydraulic oil, 20 l, aftermarket

In stock

0,00 ₺

48013

Meguin HLP R 32 hydraulic oil, 200 l, aftermarket

In stock

0,00 ₺

48008

Meguin HLP R 46 hydraulic oil, 20 l, aftermarket

In stock

0,00 ₺

HT2/220-039

Multipurpose HT 2 high-temperature grease, 390 g, aftermarket

In stock

0,00 ₺

HT2/220-04

Multipurpose HT 2 high-temperature grease, 400 g, aftermarket

In stock

0,00 ₺

NeoZoneX Glide Summer EP2

NeoZoneX Glide Summer slide pad grease, 1 kg, aftermarket

In stock

0,00 ₺

NF 1125

NF 1125 glass bonding kit, aftermarket

In stock

0,00 ₺

601216442

OPET Fullgear CT 10W transmission oil, 18 l, aftermarket

In stock

0,00 ₺

QFG016S40

ORLEN Greasen Complex 2 grease, 400 g, aftermarket

In stock

0,00 ₺

QFG021S40

ORLEN Greasen Grafit graphite grease, 400 g, aftermarket

In stock

0,00 ₺

QFS162K20

ORLEN Hydrol HLP 46 hydraulic oil, 20 l, aftermarket

In stock

0,00 ₺

85423

New

Qualitet Hidraulic HLP 32 hydraulic oil, 20 l, aftermarket

In stock

0,00 ₺

85461

New

Qualitet Hidraulic HLP 46 hydraulic oil, 20 l, aftermarket

In stock

0,00 ₺

Showing 169 to 192 of 219 (10 Pages)

Oils, greases and service chemicals (page 8)