- BrandJCB
- Article9521A030H
- Machine systemFuel system
- Part typeFuel injection pump
- Machine brandJCB
- Manufacturing typeOriginal
- All the features
For the Perkins-engined JCB machines: fuel injection pump 9521A030H, a genuine JCB part.
The pump is chosen by part number for the engine type and version: pumps for different power versions of the same engine are set differently, and the wrong pump changes power, smoke and fuel use. The pump maker's number on the card identifies its calibration. Before replacing the pump, check the fuel filters, water separator and lift pump, as the cause of failure is often poor supply or dirty fuel, and unless that is fixed a new pump will soon fail too. Older numbers on the card are earlier versions of the same pump. The label on the pump is kept, as it is used to confirm the part number.
Specifications
| Part number | 9521A030H |
| Manufacturer | JCB |
| Production type | Original |
| Part type | Fuel injection pump |
| System / group | Fuel system |
| Machine make | JCB |
Compatibility
According to the product card, 9521A030H is a fuel injection pump. Fit is confirmed by the part number. Other parts are in Fuel injection pumps.
Fitting
Before removing the pump, turn the engine until the timing marks line up and mark the position of the pump gear. Cap the fuel line ends at once. Fit the new pump in the timed position following the engine maker's instructions and tighten the connections with new seals to the specified torque. Then bleed the fuel system, without cranking for long on the first start. Once the engine runs, check for fuel leaks, idle, smoke and power, and read the fault codes on electronic systems. In the first hours, keep an eye on fuel consumption and exhaust smoke.
Specifications
- Machine systemFuel system
- Part typeFuel injection pump
- Machine brandJCB
- Manufacturing typeOriginal
No questions about this product.
