Belts for JCB Dieselmax, Perkins, Isuzu

Categories

07/10/2026 27

JCB JS200–JS260 Monitor Messages: What They Mean and What to Check

On JCB JS200, JS210, JS220, JS240 and JS260 tracked excavators with the AMS control system, the monitor in the cab shows the working mode, the time, gauges for oil temperature, coolant temperature and fuel level, and warnings in the message line. Each message first of all points to a real problem: low fuel or coolant, a blocked filter, overheating. But if a message stays on after the cause has been put right, the sensor, wiring or controller is at fault. Below is what each message means and what to check, based on Section C of JCB service manual 9803/6400.

07/10/2026 34

JCB JS200–JS260 Track Tension: How to Check the Sag and Adjust the Tracks

Track tension on the JCB JS200, JS210, JS220, JS240 and JS260 tracked excavators should be checked every shift. With the track raised off the ground, the gap between the underside of the track frame and the top of the track shoe at the fourth bottom roller from the front should be 275–295 mm on hard ground and 320–340 mm on soft sand and sticky clay. Tension is adjusted with grease through the valve on the track adjuster cylinder. The procedure below follows Section 3 of JCB service manual 9803/6400.

07/10/2026 22

JCB 3CX and 4CX Dipper Ram Creep: Causes, Ram Creep Tests and Repair

If the dipper of a JCB 3CX or 4CX backhoe loader drops on its own under load, there are three possible causes: a leaking piston seal in the ram, spool leakage in the excavator valve section, or a leaking auxiliary relief valve (ARV) in that section. The JCB service manual gives a test procedure that identifies the culprit before the ram is removed and stripped. Below are the test sequence, the permitted creep and the repair rules from Section E of service manual 9803/3290.

07/10/2026 26

JCB 3CX and 4CX Hydraulic Oil: HP32 or HP46, System Capacity and Changing the Oil

For the hydraulic system of JCB 3CX and 4CX backhoe loaders, the JCB service manual recommends ISO VG32 oil — JCB Hydraulic Fluid HP32 — at air temperatures below +38 °C. The more viscous ISO VG46, JCB High Performance Hydraulic Oil, is for air temperatures above +38 °C only. Machines with Advanced EasyControl joysticks need a separate all-season HV class oil, JCB Multigrade Anti Shear. The hydraulic system holds approximately 130 litres. The oil is changed every 2000 hours and the filter at every 500-hour service.

07/10/2026 33

JCB 3CX and 4CX Antifreeze: Which Coolant to Use, How Much and How to Change It

On JCB 3CX and 4CX backhoe loaders with the JCB Dieselmax engine, the coolant is renewed every two years, at the 2000-hour service. The cooling system holds 18.5 litres. The JCB service manual calls for an ethylene glycol antifreeze to ASTM D6210 with corrosion inhibitors and rules out organic acid technology (OAT) products. The standard mix is 50%, which gives protection down to −40 °C. Below we cover choosing, checking and changing the antifreeze as described in Section 3 of JCB service manual 9803/3290.

Default Name Model

320/08599

Belt 1855 mm 320/08599 JCB 444, genuine

In stock

0,00 ₺

320/08686

Belt 1909 mm 320/08686 JCB JS, aftermarket

In stock

0,00 ₺

320/08647

Belt 1929 mm 320/08647 JCB 444, aftermarket

In stock

0,00 ₺

320/08601

Belt 1955 mm 320/08601 JCB 444, genuine

In stock

0,00 ₺

320/08764

Belt 2008 mm 320/08764 JCB 444, genuine

In stock

0,00 ₺

320/08604

Belt 2011 mm 320/08604 JCB 444, genuine

In stock

0,00 ₺

320/08604

Belt 2056 mm 320/A8523 JCB 444, aftermarket

In stock

0,00 ₺

320/08605

Belt 2093 mm 320/08605 JCB 444, genuine

In stock

0,00 ₺

320/08606

Belt 2110 mm 320/08606 JCB 444, genuine

In stock

0,00 ₺

320/08600

Belt 2121 mm 320/08600 JCB 444, genuine

In stock

0,00 ₺

390-0532

Belt 390-0532 CAT, aftermarket

In stock

0,00 ₺

212-9353

Belt 390-0536 CAT, aftermarket

In stock

0,00 ₺

320/08671

Belt 995 mm 320/08671 JCB 444, genuine

In stock

0,00 ₺

02/800774

Belt pair 02/800774 Isuzu, aftermarket

In stock

0,00 ₺

02/800774

Belt pair 02/800774 Isuzu, genuine

In stock

0,00 ₺

332/E5806

Drive belt guard 332/E5806 JCB, genuine

In stock

0,00 ₺

02/801100

Fan belt 02/801100 Isuzu, aftermarket

In stock

0,00 ₺

8.8675

Fan belt set of 2 850x8.5x8 mm JCB, aftermarket

In stock

0,00 ₺

333H5004

V-belt CAT, aftermarket

In stock

0,00 ₺

02/201291

V-belt pair 02/201291 Perkins, aftermarket

In stock

0,00 ₺

Showing 49 to 68 of 68 (3 Pages)

Engine belts (page 3)