Buckets, teeth, side cutters, edges

Categories

07/10/2026 27

JCB JS200–JS260 Monitor Messages: What They Mean and What to Check

On JCB JS200, JS210, JS220, JS240 and JS260 tracked excavators with the AMS control system, the monitor in the cab shows the working mode, the time, gauges for oil temperature, coolant temperature and fuel level, and warnings in the message line. Each message first of all points to a real problem: low fuel or coolant, a blocked filter, overheating. But if a message stays on after the cause has been put right, the sensor, wiring or controller is at fault. Below is what each message means and what to check, based on Section C of JCB service manual 9803/6400.

07/10/2026 34

JCB JS200–JS260 Track Tension: How to Check the Sag and Adjust the Tracks

Track tension on the JCB JS200, JS210, JS220, JS240 and JS260 tracked excavators should be checked every shift. With the track raised off the ground, the gap between the underside of the track frame and the top of the track shoe at the fourth bottom roller from the front should be 275–295 mm on hard ground and 320–340 mm on soft sand and sticky clay. Tension is adjusted with grease through the valve on the track adjuster cylinder. The procedure below follows Section 3 of JCB service manual 9803/6400.

07/10/2026 22

JCB 3CX and 4CX Dipper Ram Creep: Causes, Ram Creep Tests and Repair

If the dipper of a JCB 3CX or 4CX backhoe loader drops on its own under load, there are three possible causes: a leaking piston seal in the ram, spool leakage in the excavator valve section, or a leaking auxiliary relief valve (ARV) in that section. The JCB service manual gives a test procedure that identifies the culprit before the ram is removed and stripped. Below are the test sequence, the permitted creep and the repair rules from Section E of service manual 9803/3290.

07/10/2026 26

JCB 3CX and 4CX Hydraulic Oil: HP32 or HP46, System Capacity and Changing the Oil

For the hydraulic system of JCB 3CX and 4CX backhoe loaders, the JCB service manual recommends ISO VG32 oil — JCB Hydraulic Fluid HP32 — at air temperatures below +38 °C. The more viscous ISO VG46, JCB High Performance Hydraulic Oil, is for air temperatures above +38 °C only. Machines with Advanced EasyControl joysticks need a separate all-season HV class oil, JCB Multigrade Anti Shear. The hydraulic system holds approximately 130 litres. The oil is changed every 2000 hours and the filter at every 500-hour service.

07/10/2026 33

JCB 3CX and 4CX Antifreeze: Which Coolant to Use, How Much and How to Change It

On JCB 3CX and 4CX backhoe loaders with the JCB Dieselmax engine, the coolant is renewed every two years, at the 2000-hour service. The cooling system holds 18.5 litres. The JCB service manual calls for an ethylene glycol antifreeze to ASTM D6210 with corrosion inhibitors and rules out organic acid technology (OAT) products. The standard mix is 50%, which gives protection down to −40 °C. Below we cover choosing, checking and changing the antifreeze as described in Section 3 of JCB service manual 9803/3290.

Default Name Model

980/89881

Backhoe bucket 350 mm 980/89881 JCB 3CX/4CX, aftermarket

In stock

0.00 ₺

400 mm

Backhoe bucket 400 mm CAT, aftermarket

In stock

0.00 ₺

980/89992

Backhoe bucket 500 mm 980/89992 JCB 3CX/4CX, aftermarket

In stock

0.00 ₺

cc8b59cc-ad2c-11ed-bbb1-ac1f6b72b994

Backhoe bucket 700 mm JCB 3CX/4CX, aftermarket

In stock

0.00 ₺

980/89994

Backhoe bucket 800 mm 980/89994 JCB 3CX/4CX, aftermarket

In stock

0.00 ₺

331/65868

Bucket cutting edge 1830 mm 331/65868 JCB 3CX/4CX, aftermarket

In stock

0.00 ₺

275699А1

Bucket tip 275699A1 Case, aftermarket

In stock

0.00 ₺

333/F1404

Bucket tip 333/F1404 JCB JS, aftermarket

In stock

0.00 ₺

980/84670

Bucket tip 980/84670 JCB JS, aftermarket

In stock

0.00 ₺

980/84766

Bucket tip 980/84766 JCB JS, aftermarket

In stock

0.00 ₺

ZD300T-220

Bucket tip ZD300T-220 XCMG, aftermarket

In stock

0.00 ₺

6Y6335

Bucket tooth 6Y6335 CAT, aftermarket, option 2

In stock

0.00 ₺

1U3302

Cast 5.8 kg rock bucket tip 1U3302 CAT, aftermarket

In stock

0.00 ₺

980/88833

Fabricated quick hitch 980/88833 JCB 3CX/4CX, aftermarket

In stock

0.00 ₺

205-70-19570 /KNL

Forged bucket tip 205-70-19570 Komatsu, aftermarket

In stock

0.00 ₺

1U3352RC

Forged rock bucket tip 1U3352 CAT, aftermarket

In stock

0.00 ₺

205-70-19570 RC

Forged rock bucket tip 205-70-19570 Komatsu, aftermarket

In stock

0.00 ₺

522/07000

Grading bucket 1200 mm 522/07000 JCB 3CX/4CX, aftermarket

In stock

0.00 ₺

ae81f306-ad2c-11ed-bbb1-ac1f6b72b994

Grading bucket 1300 mm JCB 3CX/4CX, aftermarket

In stock

0.00 ₺

993/99189

HB400 double-sided edge 2345x20x210 993/99189 JCB 3CX/4CX, OEM

In stock

0.00 ₺

990/69901

HB400 double-sided edge 2450x20x210 990/69901 JCB 3CX/4CX, OEM

In stock

0.00 ₺

123/02362

HB400 grading edge 2345x16x130 123/02362 JCB 3CX/4CX, OEM

In stock

0.00 ₺

123/05115

HB400 grading edge 2450x16x130 123/05115 JCB 3CX/4CX, OEM

In stock

0.00 ₺

9N4352/KN

J350 bucket tip 9N4352 CAT, aftermarket

In stock

0.00 ₺

Showing 73 to 96 of 110 (5 Pages)

Buckets and bucket parts (page 4)