- BrandBOYPAR
- Article458/20061
- Machine systemFront axle
- Part typeKnuckle trunnion
- Machine brandJCB
- Manufacturing typeAftermarket
- CompatibilityJCB 3CX, 4CX
- All the features
Knuckle trunnion (bearing cap) 458/20061 is an aftermarket part for the JCB 3CX and 4CX backhoe loaders.
The trunnion (kingpin cap) is the pin and bearing cap on which the steering knuckle of a steered axle pivots on the axle casing. The upper and lower trunnions carry the knuckle through taper bearings and allow it to steer. When the trunnion surface or bearing seat wears, play develops at the knuckle, the steering becomes loose and the tyres wear unevenly. Trunnions that are not greased wear quickly. Trunnions must be greased regularly.
Specifications
| Part number | 458/20061 |
| Production type | Aftermarket |
| Part type | Knuckle trunnion |
| System / group | Front axle |
| Machine make | JCB |
Compatibility
According to sources, 458/20061, 453/30401, 448/42402 and 453/00304 are numbers of the knuckle trunnion of JCB 3CX and 4CX backhoe loaders, also sold as a kit with bearing 907/08300 and seal 904/06700. The catalogue also has the OEM version of this part. Other parts are in Reduction gears.
Fitting
For the change, raise the wheel and support the knuckle. Remove the trunnion bolts, then the trunnion and shims. Fit the new trunnion with its bearing and seal, tighten the bolts to torque in a cross pattern and set the preload by measuring the knuckle's turning resistance. Finally, grease through the nipple. The trunnion comes new, and its grease passage is checked to be clear.
Specifications
- Machine systemFront axle
- Part typeKnuckle trunnion
- Machine brandJCB
- Manufacturing typeAftermarket
- CompatibilityJCB 3CX, 4CX
No questions about this product.
