Rear lights switch 701/58827 JCB, aftermarket

For the JCB machines: rear lights switch 701/58827, an aftermarket part.

This switch is listed in the product card as the rear work lights switch, number 701/58827, from the angled-rocker panel switch series. The rear work lights illuminate the area behind during backhoe work and reversing. The switch drives the lamp relay, and if it runs hot the relay and wiring are checked too. The switch pins are numbered, and the wires go onto the same numbers on the new switch.

Specifications

Compatibility

Other parts are in Rocker switches.

Fitting

Switch off the ignition before the change. Remove the switch from the panel by pressing the clips at the back or gently lifting its bezel, and unplug the connector without pulling the wires. Push the new switch fully onto the connector and press it into the panel until the clips lock. After the change, check every position of the switch and the related function. If the pins at the back are darkened or melted, check the harness connector too, since a faulty connector will heat the new switch as well. After the change, test the function in every position. Rocker switches are held in the panel by their side clips, and a switch with broken clips can be pushed into the panel when used.