Cylinder eye bush 809/04006 JCB Loadall, aftermarket

For the JCB Loadall telehandlers: cylinder eye bush 809/04006, an aftermarket part.

The bush is chosen by bore, outside diameter and length; sources list this part as the end bush of the JCB Loadall lift cylinder. When changing the bush, measure the pin too, since a worn pin soon ruins a new bush. Bushed joints need regular greasing. Most bushed joints are greased through a nipple, and the grease also keeps dirt out of the gap between pin and bush.

Specifications

Compatibility

According to sources, 809/04006 is the lift cylinder end bush of JCB Loadall telehandlers; the product card gives it as a bush bearing. The catalogue also has the genuine version of this part. Other parts are in Bearings.

Fitting

Remove the old bush with a suitable mandrel or puller without heating the cylinder eye. Clean the eye, press the new bush in squarely and, if it has a lubrication hole, line it up with the grease channel. Fit the pin with grease and grease the joint. When changing the bush, check the bush and pin at the other end of the cylinder too, since unless the play at both ends is removed the cylinder will still take side loads. If the cylinder seals are leaking, it is advisable to renew the seal kit in the same job.