- BrandJF Parts
- Article921/53300
- Machine systemTransmission
- Part typeCollapsible spacer
- Machine brandJCB
- Manufacturing typeAftermarket
- CompatibilityJCB 3CX, 4CX
- All the features
Pinion collapsible spacer 921/53300 is an aftermarket part for the JCB 3CX and 4CX backhoe loaders.
The collapsible spacer sits on the pinion shaft between the two taper bearings and is crushed in a controlled way as the pinion nut is tightened, giving the bearings the correct preload. Once crushed it cannot recover, so a new one is fitted every time the pinion is dismantled. Reusing the old spacer means the preload will not hold, leading to pinion play and early bearing failure. The pinion nut is tightened in stages while measuring the torque needed to turn the pinion; a spacer crushed too far cannot be undone and must be replaced again. The old spacer is not used as a gauge.
Specifications
| Part number | 921/53300 |
| Production type | Aftermarket |
| Part type | Collapsible spacer |
| System / group | Transmission |
| Machine make | JCB |
Compatibility
According to sources, 921/53300 and 448/05402 are numbers of the JCB axle pinion collapsible spacer; the product card gives it as the front axle pinion bush. Other parts are in Reduction gears.
Fitting
When the pinion is dismantled, discard the old spacer and fit a new one. Tighten the nut in stages until the turning torque in the service manual is reached, renewing the pinion seal and fitting the propshaft flange clean at the same time. Lock the nut after assembly. The spacer comes new.
Specifications
- Machine systemTransmission
- Part typeCollapsible spacer
- Machine brandJCB
- Manufacturing typeAftermarket
- CompatibilityJCB 3CX, 4CX
No questions about this product.
