Rear window strut 6099599M91 Terex, aftermarket

For the Terex and Massey Ferguson backhoe loaders: rear window strut 6099599M91, an aftermarket part. This strut is for the rear window.

The strut is chosen by part number according to length, stroke, force (in newtons) and end fittings: one that is too strong makes the door hard to close, while one that is too weak will not hold it open. Struts fitted in pairs (for example on each side of a bonnet) are replaced together. Gas struts need no maintenance, but their rods are kept clean and protected from knocks. A weakening strut shows when the open panel starts to sink slowly.

Specifications

Compatibility

According to the product card, 6099599M91 is a gas strut. Fit is confirmed by the part number. Other parts are in Cab.

Fitting

Before the change, prop the door, bonnet or window open with a separate support. Release the old strut's ends from their clips or bolts. Fit the new strut, usually with the rod pointing down, and lock the end fittings. After fitting, open and close the panel a few times to check it stays fully open. The prop holding the panel is not removed until the job is finished. A new strut's force settles after the first few openings.