Intermediate propshaft 914/60134 JCB 426/436, aftermarket

Intermediate propshaft 914/60134 is an aftermarket part for the JCB wheel loaders. This shaft works as the intermediate shaft between two propshafts.

The propshaft is checked with the machine stopped and the parking brake on: play felt in the joints or splines when the shaft is rocked by hand shows wear. Any guard must be intact. A damaged propshaft can break at speed and damage the hoses and cables around it, so a worn shaft is replaced without delay.

Specifications

Compatibility

According to sources, 914/60134 is the intermediate propshaft used on JCB wheel loaders; the product card gives it for the JCB 426. Other parts are in Axle shafts, propshafts and U-joints.

Fitting

Before the change, park the machine on level ground, apply the parking brake and chock the wheels. Support the shaft while undoing the flange bolts; fit the new shaft with the marks on the sliding section aligned and tighten the flange bolts to the specified torque. After fitting, grease the joints and splines and drive at low speed to check for vibration. The shaft comes new; clean the flange faces before fitting and check the marks on the sliding section. The shaft comes new.