- BrandBOYPAR
- Article448/42703
- Machine systemFront axle
- Part typeSteering knuckle
- Machine brandJCB
- Manufacturing typeAftermarket
- CompatibilityJCB 3CX, 4CX
- All the features
For the JCB 3CX and 4CX backhoe loaders: steering knuckle, right 458/20405, an aftermarket part. This part is for the right-hand side.
Knuckles are handed left and right and are chosen by part number for the same side and axle type as the old part. During the change, check the trunnion bearings, seals, shims and track rod connection; the bearings and seals are usually renewed together with the knuckle. After assembly, set the trunnion bearing preload and check the steering lock stops.
Specifications
| Part number | 458/20405 |
| Production type | Aftermarket |
| Part type | Steering knuckle |
| System / group | Front axle |
| Machine make | JCB |
Compatibility
The product card gives it as the JCB 3CX right-hand steering knuckle, numbers 458/20405, 448/42703 and 448/42701; the left-hand side uses 458/20404. The catalogue also has the genuine version of this part. Other parts are in Reduction gears.
Fitting
For the change, remove the wheel, planetary gearbox and axle shaft and drain the axle oil. Fit the knuckle with its trunnion bearings and shims, tighten the trunnion bolts to torque and set the preload by measurement. Connect the track rod and steering cylinder, renew the seals, top up the axle oil and check the wheel alignment. The knuckle comes new; its seats and bores are cleaned and checked before assembly.
Specifications
- Machine systemFront axle
- Part typeSteering knuckle
- Machine brandJCB
- Manufacturing typeAftermarket
- CompatibilityJCB 3CX, 4CX
No questions about this product.
