- BrandMULTI
- ArticleS06/42927
- Machine systemHydraulic system
- Part typeO-ring
- Machine brandHIDROMEK
- Manufacturing typeAftermarket
- Machine seriesHMK 102B, HMK 102S, HMK 105, HMK 62
- All the features
For the Hidromek backhoe loaders: o-ring S06/42927, an aftermarket part.
A ring is defined by inside diameter, cross-section and material, and even rings that look alike can differ in hardness or material. In hydraulic and fuel systems a ring of the wrong material swells or cracks, and in high-pressure joints a size mismatch lets the ring extrude from its groove. The ring is therefore chosen by part number.
Specifications
| Part number | S06/42927 |
| Production type | Aftermarket |
| Part type | O-ring |
| System / group | Hydraulic system |
| Machine make | HIDROMEK |
| Series / model | HMK 102B, HMK 102S, HMK 105, HMK 62 |
Compatibility
According to the product card, S06/42927 is an O-ring. Fit is confirmed by the part number. Other parts are in Seals and oil seals.
Fitting
On assembly, clean the groove and mating face, wet the ring with the working fluid or suitable grease and seat it without twisting. Protect the ring as it passes sharp edges and threads, tighten the joint to the specified torque and check for leaks under pressure. Spare rings are stored somewhere cool and dark, away from sunlight and ozone, since rubber left in the light cracks at the surface and starts leaking soon after fitting. Before fitting, inspect the ring for cracks, cuts and moulding flash.
Specifications
- Machine systemHydraulic system
- Part typeO-ring
- Machine brandHIDROMEK
- Manufacturing typeAftermarket
- Machine seriesHMK 102B, HMK 102S, HMK 105, HMK 62
No questions about this product.
