Shaped circlip 826/01048 JCB, aftermarket

Shaped circlip 826/01048 is an aftermarket part for the JCB machines. According to the product card, this part is a shaped circlip.

Fit the circlip with suitable circlip pliers and open it only as far as needed to reach the groove, as an over-opened circlip is permanently deformed. After fitting, turn the circlip to check that it is fully seated in the groove. On circlips with a sharp edge, the flat face goes towards the side the load comes from. The groove itself is checked too, as even a new circlip will not stay in a worn or burred groove.

Specifications

Compatibility

According to the product card, 826/01048 is a circlip. Fit is confirmed by the part number. Other parts are in Fasteners.

Fitting

Before removing the circlip, clean around it and hold it so that it does not fly off. Seat the new circlip fully in the groove and check it once more before the unit is put under load.