- BrandHATVE HTV
- Article450/10700
- Machine systemTransmission
- Part typeCrown wheel and pinion
- Machine brandJCB
- Manufacturing typeAftermarket
- CompatibilityJCB 3CX, 4CX
- All the features
Crown wheel and pinion 450/10700 is an aftermarket part for the JCB 3CX and 4CX backhoe loaders. The set's ratio is 13/38.
Crown wheel and pinion sets differ in ratio, spiral direction (right or left hand), pinion thread and mounting dimensions, so two similar-looking sets may not fit the same axle. The set is therefore chosen by part number and the tooth counts on the old set. On four-wheel-drive machines the front and rear axle ratios must match each other, since different ratios strain the driveline and wear the tyres.
Specifications
| Part number | 450/10700 |
| Production type | Aftermarket |
| Part type | Crown wheel and pinion |
| System / group | Transmission |
| Machine make | JCB |
Compatibility
According to sources, 450/10700 and 458/70037 are numbers of the same 13/38 M24 crown wheel and pinion, used on JCB 3C, 3CX and 3D and 214-217 backhoe loaders. Other parts are in Reduction gears.
Fitting
Fitting a crown wheel and pinion is precise work needing measuring tools and should be done by an experienced workshop. Pinion depth is set with shims and backlash with the differential bearing adjustment, then the tooth contact pattern is checked with marking compound. Pinion bearing preload and pinion nut torque are set to the service manual. After assembly, fill the axle with the specified oil and check for whine and heat during the first hours.
Specifications
- Machine systemTransmission
- Part typeCrown wheel and pinion
- Machine brandJCB
- Manufacturing typeAftermarket
- CompatibilityJCB 3CX, 4CX
No questions about this product.
